Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY (for Bench Seat Type) › from 2019.06
RM35X0E _58 Vehicle Interior _079257 SUPPLEMENTAL RESTRAINT SYSTEMS _0384941 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Bench Seat Type) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Bench Seat Type)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 89178C 1.INSTALL NO. 2 AIRBAG BRACKET

a.
B524624

Install the No. 2 airbag bracket to the front seat airbag assembly RH with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

CAUTION:

Do not reuse the nut.



Hide 73910B 2.INSTALL FRONT SEAT AIRBAG ASSEMBLY RH

a.
B535126

Install the front seat airbag assembly RH together with the No. 2 airbag bracket with a new nut.

CAUTION:

Do not reuse the nut.


Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


b.
B535125

Connect the airbag wire harness to the seatback side:

NOTICE:

When disconnecting the airbag wire harness, take care not to damage the airbag wire harness.


i.

Attach the wire harness clamp.



c.
B535124

Connect the airbag wire harness to the seat cushion side:

NOTICE:

When disconnecting the airbag wire harness, take care not to damage the airbag wire harness.


i.

Attach the wire harness clamp.


ii.

Attach the claw to connect the airbag connector.



Hide 71073A 5.INSTALL FRONT SEATBACK COVER SUB-ASSEMBLY RH

Hide 71705F 6.INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY RH (for Wagon)

Hide 73178A 7.INSTALL SEAT BELT ANCHOR COVER CAP

Hide 73373 8.INSTALL REAR SEAT SHOULDER BELT COVER

Hide 71811T 10.INSTALL FRONT SEAT CUSHION SHIELD RH

Hide 72525M 11.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH

Hide 72329D 12.INSTALL SEAT ADJUSTER BOLT COVER RH

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 15. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART