The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel suction plate sub-assembly (fuel filter) removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.
Click hereEngine / Hybrid System>7GR-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
1. PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
77020A
3.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
83320
4.REMOVE FUEL SENDER GAUGE ASSEMBLY
5.REMOVE NO. 1 FUEL SUB-TANK
23217D
6.REMOVE FUEL PUMP FILTER
7.REMOVE FUEL PUMP
23070
8.REMOVE FUEL MAIN VALVE ASSEMBLY
23070
9.INSTALL FUEL MAIN VALVE ASSEMBLY
10.INSTALL FUEL PUMP
23217D
11.INSTALL FUEL PUMP FILTER
12.INSTALL NO. 1 FUEL SUB-TANK
83320
13.INSTALL FUEL SENDER GAUGE ASSEMBLY
77020A
14.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
15.CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
16. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART