- NOTICE:
·
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
- HINT:
·
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
·
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
*1: for Automatic Transmission
*2: for Manual Transmission
*3: for 7GR-FKS
*4: for 1GD-FTV
*5: w/ Parking Assist Monitor System
*6: w/o Panoramic View Monitor System
*7: w/ Panoramic View Monitor System
*8: for 1GD-FTV for EGR with Exhaust Gas Temperature Sensor
Entire System
| Symptom
|
Suspected Area
|
Link
|
| System does not operate at all
|
CAN communication system
|
|
| Meter/gauge system
|
|
| Proceed to "Power Source Circuit"
|
|
| Steering pad switch assembly
|
|
| Spiral cable sub-assembly
|
|
| Blind spot monitor sensor LH
|
|
| System cannot be turned off
|
CAN communication system
|
|
| Meter/gauge system
|
|
| Steering pad switch assembly
|
|
| Spiral cable sub-assembly
|
|
| Blind spot monitor sensor LH
|
|
| "Blind Spot Monitor Unavailable" or "Blind Spot Monitor Malfunction Visit Your Dealer" is displayed on the multi-information display
|
Check abnormality history
|
|
| Blind spot monitor sensor RH
|
|
| Blind spot monitor sensor LH
|
|
| Combination meter assembly
|
|
| "Rear Cross Traffic Alert Unavailable" or "Rear Cross Traffic Alert Malfunction Visit Your Dealer" is displayed on the multi-information display
|
Check abnormality history
|
|
| Blind spot monitor sensor RH
|
|
| Blind spot monitor sensor LH
|
|
| Combination meter assembly
|
|
Blind Spot Monitor Function
| Symptom
|
Suspected Area
|
Link
|
| Outer rear view mirror indicator LH does not illuminate
|
Proceed to "Blind Spot Monitor Beam Axis Confirmation"
|
|
| Outer mirror LH (outer rear view mirror indicator LH)
|
|
| Outer mirror retractor LH*6
|
|
| Outer rear view mirror assembly LH*7
|
|
| Blind spot monitor sensor LH
|
|
| Outer rear view mirror indicator RH does not illuminate
|
Proceed to "Blind Spot Monitor Beam Axis Confirmation"
|
|
| Outer mirror RH (outer rear view mirror indicator RH)
|
|
| Outer mirror retractor RH*6
|
|
| Outer rear view mirror assembly RH*7
|
|
| Blind spot monitor sensor RH
|
|
| Outer rear view mirror indicator LH remains illuminated
|
Proceed to "Blind Spot Monitor Beam Axis Confirmation"
|
|
| Blind spot monitor sensor LH
|
|
| Outer rear view mirror indicator RH remains illuminated
|
Proceed to "Blind Spot Monitor Beam Axis Confirmation"
|
|
| Blind spot monitor sensor RH
|
|
| Outer rear view mirror indicator LH does not flash
|
Proceed to "Turn Signal Light" in Problem Symptoms Table for the Lighting (EXT) section
|
|
| Blind spot monitor sensor LH
|
|
| Outer rear view mirror indicator RH does not flash
|
Proceed to "Turn Signal Light" in Problem Symptoms Table for the Lighting (EXT) section
|
|
| Blind spot monitor sensor RH
|
|
| Outer rear view mirror indicator LH continues to flash
|
Blind spot monitor sensor LH
|
|
| Outer rear view mirror indicator RH continues to flash
|
Blind spot monitor sensor RH
|
|
RCTA Function
| Symptom
|
Suspected Area
|
Link
|
Function does not operate at all
(Blind spot monitor function operates normally)
|
Data List / Active Test (Reverse)
|
|
| Automatic transmission system (for 7GR-FKS)*1, *3
|
|
| Automatic transmission system (for 1GD-FTV)*1, *4
|
|
| Automatic transmission system (for 1GD-FTV for EGR with Exhaust Gas Temperature Sensor)*1, *8
|
|
| Manual transmission system (for 7GR-FKS)*2, *3
|
|
| Manual transmission system (for 1GD-FTV)*2, *4
|
|
| Blind spot monitor sensor RH
|
|
| While RCTA function is active, outer rear view mirror indicator flashes but RCTA buzzer does not sound.
|
Proceed to "Buzzer does not Sound"
|
|
| When shift position is in R, detection operation is normal but RCTA indicator does not appear on the display of radio and display receiver assembly.
|
CAN communication system
|
|
| Television camera assembly*5
|
|
| Parking Assist ECU*7
|
|
| Blind spot monitor sensor LH
|
|
| Blind spot monitor sensor RH
|
|
| Radio and display receiver assembly
|
|