Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (for Water Cooled Type Intercooler) › from 2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0412266 ECD SYSTEM(for Water Cooled Type Intercooler) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(for Water Cooled Type Intercooler)  P05442A  Exhaust Gas Temperature Sensor 1 Bank 1 Signal Stuck In Range  P20312A  Exhaust Gas Temperature Sensor 2 Bank 1 Signal Stuck In Range  P242A2A  Exhaust Gas Temperature Sensor 3 Bank 1 Signal Stuck In Range  P246E2A  Exhaust Gas Temperature Sensor 4 Bank 1 Signal Stuck In Range  


DESCRIPTION


DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P05442A Exhaust Gas Temperature Sensor 1 Bank 1 Signal Stuck In Range The change in the exhaust temperature sensors from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (approximately 15 minutes) is small.
(2 trip detection logic)
·

Exhaust gas temperature sensor

·

ECM (soak timer)


Comes on DTC stored SAE Code: P2080
P20312A Exhaust Gas Temperature Sensor 2 Bank 1 Signal Stuck In Range The change in the No. 2 exhaust temperature sensors from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (approximately 15 minutes) is small.
(2 trip detection logic)
·

No. 2 exhaust gas temperature sensor

·

ECM (soak timer)


Comes on DTC stored SAE Code: P2084
P242A2A Exhaust Gas Temperature Sensor 3 Bank 1 Signal Stuck In Range The change in the No. 3 exhaust temperature sensors from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (approximately 15 minutes) is small.
(2 trip detection logic)
·

No. 3 exhaust gas temperature sensor

·

ECM (soak timer)


Comes on DTC stored SAE Code: P242B
P246E2A Exhaust Gas Temperature Sensor 4 Bank 1 Signal Stuck In Range The change in the No. 4 exhaust temperature sensors from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (approximately 15 minutes) is small.
(2 trip detection logic)
·

No. 4 exhaust gas temperature sensor

·

ECM (soak timer)


Comes on DTC stored SAE Code: P246F

Related Data List
DTC No. Data List
P05442A
P20312A
P242A2A
P246E2A
·

Exhaust Temperature B1S1

·

Exhaust Temperature B1S2

·

Exhaust Temperature B1S3

·

Exhaust Temperature B1S4



HINT:
·

Sensor 1 represents the sensor located upstream of the DOC catalytic converter.

·

Sensor 2 represents the sensor located upstream of the DPF catalytic converter.

·

Sensor 3 represents the sensor located downstream of the DPF catalytic converter.

·

Sensor 4 represents the sensor located downstream of the SCR catalyst.

·

If DTC P05442A, P20312A and/or P242A2A is stored, the following symptoms may appear:

-

White smoke




CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P05442A Check the exhaust gas temperature after leaving the vehicle for 1 to 2 hours and after driving*
P20312A Check the No. 2 exhaust gas temperature after leaving the vehicle for 1 to 2 hours and after driving*
P242A2A Check the No. 3 exhaust gas temperature after leaving the vehicle for 1 to 2 hours and after driving*
P246E2A Check the No. 4 exhaust gas temperature after leaving the vehicle for 1 to 2 hours and after driving*

*: Drive the vehicle for 5 minutes or more at a speed of 50 km/h (31.1 mph) or more.

CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (for Water Cooled Type Intercooler)>REGISTRATION) and initialization (Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (for Water Cooled Type Intercooler)>INITIALIZATION).


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P05442A, P20312A, P242A2A OR P246E2A)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

d.

Read the DTCs.

Result:
Result Proceed to
DTC P05442A, P20312A, P242A2A or P246E2A is output A
DTC P05442A, P20312A, P242A2A or P246E2A and other DTCs are output B




A

2.READ VALUE USING GTS (EXHAUST TEMPERATURE)

B

2.READ VALUE USING GTS (EXHAUST TEMPERATURE)
a.

Leave the vehicle as is for 1 to 2 hours with the engine stopped.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Diesel Exhaust / Exhaust Temperature B1S1, Exhaust Temperature B1S2, Exhaust Temperature B1S3 and Exhaust Temperature B1S4.

Powertrain > Engine > Data List
Tester Display
Exhaust Temperature B1S1
Exhaust Temperature B1S2
Exhaust Temperature B1S3
Exhaust Temperature B1S4
50003 372 1133,1134,1135,1136

e.

Record the exhaust temperature displayed on the GTS.


Result:
Proceed to
NEXT



NEXT

3.INSPECT EXHAUST GAS TEMPERATURE SENSOR
3.INSPECT EXHAUST GAS TEMPERATURE SENSOR
a.

Drive the vehicle for 5 minutes or more at a speed of 50 km/h (31.1 mph) or more.


b.

Stop the vehicle.


c.

Connect the GTS to the DLC3.


d.

Enter the following menus: Powertrain / Engine / Data List / Diesel Exhaust / Exhaust Temperature B1S1, Exhaust Temperature B1S2, Exhaust Temperature B1S3 and Exhaust Temperature B1S4.

Powertrain > Engine > Data List
Tester Display
Exhaust Temperature B1S1
Exhaust Temperature B1S2
Exhaust Temperature B1S3
Exhaust Temperature B1S4
50003 372 1133,1134,1135,1136

e.

Read the value.

Result:
Result Proceed to
Difference between Exhaust Temperature B1S1 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and Exhaust Temperature B1S1 checked after driving is within +/-15°C (27°F) A
Difference between Exhaust Temperature B1S2 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and Exhaust Temperature B1S2 checked after driving is within +/-15°C (27°F)
Difference between Exhaust Temperature B1S3 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and Exhaust Temperature B1S3 checked after driving is within +/-15°C (27°F)
Difference between Exhaust Temperature B1S4 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and Exhaust Temperature B1S4 checked after driving is within +/-15°C (27°F)
Difference between exhaust temperature recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and exhaust temperature checked after driving is equal to or greater than +/-15°C (27°F) B




A

4.REPLACE EXHAUST GAS TEMPERATURE SENSOR

B

6.REPLACE ECM
4.REPLACE EXHAUST GAS TEMPERATURE SENSOR
HINT:

Replace the exhaust temperature sensor that changed a small amount in "INSPECT EXHAUST GAS TEMPERATURE SENSOR".


a.

b.

Replace the No. 2 exhaust gas temperature sensor.

Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>EXHAUST GAS TEMPERATURE SENSOR>REMOVAL


c.

Replace the No. 3 exhaust gas temperature sensor.

Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>EXHAUST GAS TEMPERATURE SENSOR>REMOVAL



Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Leave the vehicle as is for 1 to 2 hours with the engine stopped.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Diesel Exhaust / Exhaust Temperature B1S1, Exhaust Temperature B1S2, Exhaust Temperature B1S3 and Exhaust Temperature B1S4.

Powertrain > Engine > Data List
Tester Display
Exhaust Temperature B1S1
Exhaust Temperature B1S2
Exhaust Temperature B1S3
Exhaust Temperature B1S4
50003 372 1133,1134,1135,1136

e.

Record the exhaust temperature displayed on the GTS.


f.

Drive the vehicle for 5 minutes or more at a speed of 50 km/h (31.1 mph) or more.


g.

Stop the vehicle.


h.

Connect the GTS to the DLC3.


i.

Enter the following menus: Powertrain / Engine / Data List / Exhaust Temperature B1S1, Exhaust Temperature B1S2, Exhaust Temperature B1S3 and Exhaust Temperature B1S4.

Powertrain > Engine > Data List
Tester Display
Exhaust Temperature B1S1
Exhaust Temperature B1S2
Exhaust Temperature B1S3
Exhaust Temperature B1S4
50003 372 1133,1134,1135,1136

j.

Check the exhaust temperature after leaving the vehicle for 1 to 2 hours and after driving.

Standard:

+/-15°C (27°F) or more



Result:
Proceed to
NEXT



NEXT

END

6.REPLACE ECM

Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED