Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › EXHAUST GAS TEMPERATURE SENSOR › from 2020.05
RM35X0E _51 Engine / Hybrid System _079220 1GD-FTV EMISSION CONTROL _0384174 EXHAUST GAS TEMPERATURE SENSOR A

1GD-FTV EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
A343692

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Cover)

Hide 17940D 2.REMOVE INTERCOOLER ASSEMBLY (for Water Cooled Type Intercooler)

Hide 89425 3.REMOVE EXHAUST GAS TEMPERATURE SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A440868

for Air Cooled Type Intercooler:

Disconnect the 3 connectors from the 3 exhaust gas temperature sensors.


b.

for Water Cooled Type Intercooler:

i.
A452834

Detach the clamp, remove the 2 bolts and disconnect the engine wire from the intercooler support bracket.


ii.
A456474

Disconnect the 3 connectors from the exhaust gas temperature sensors.



c.
A440869

Remove the nut and disconnect the No. 3 exhaust gas temperature sensor from the No. 1 vacuum pipe.


d.
A440870

Remove the bolt and open the clamp of the pipe clamp.


e.

Detach the 3 connectors from the pipe clamp.


f.
A440871

Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.


g.
A440872

Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.


h.
A440873

Using a 14 mm union nut wrench, remove the No. 3 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.