Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR (for Intercooler) › from 2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0414514 ENGINE COOLANT TEMPERATURE SENSOR(for Intercooler) A

1GD-FTV ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR(for Intercooler)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



CAUTION:
A442821

Do not remove the reserve tank cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 89422P 3.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A453972

Disconnect the engine coolant temperature sensor connector.


b.
A453973C02
1.854,1.833 1.833,2.667 1.833,2.667 2,2.667 true 2.083,2.583 2.417,2.75 0.333,0.167 10 true SST 0.948,0.771 1.26,0.969 0.313,0.198 10 true *a 2.625,2.073 2.938,2.271 0.313,0.198 10 false *b
*a Turn
*b Hold


Using SST, remove the engine coolant temperature sensor and gasket from the intercooler assembly.

SST
09817-33191  

NOTICE:

Using a wrench, etc., secure the intercooler side and loosen it so that it does not deform.