Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › from 2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387395 ENGINE COOLANT TEMPERATURE SENSOR A

1GD-FTV ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
A343702

Do not remove the radiator reservoir cap sub-assembly, vent plug, radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

·
A343690

To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hands and clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.



PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 2.DRAIN ENGINE COOLANT

a.

for Air Cooled Type Intercooler:

Click hereGeneral>MAINTENANCE>1GD-FTV COOLANT>REPLACEMENT



Hide 44320 3.DISCONNECT VANE PUMP ASSEMBLY

Hide 89422C 4.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A346005

Disconnect the engine coolant temperature sensor connector.


b.
A346049N01
1.458,1.625 1.583,1.625 1.583,1.625 1.854,1.135 true 1.156,1.542 1.479,1.698 0.323,0.156 10 true SST

Using SST, remove the engine coolant temperature sensor and gasket from the cylinder head sub-assembly.

SST
09817-33191