2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Vehicle Position Mark Deviates Greatly

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK GPS MARK

  1. E181043E08
    Check that the GPS mark is displayed.

    OK:
    GPS mark is displayed.

Text in Illustration 
*a
Example


NG
GO TO "GPS MARK IS NOT DISPLAYED" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


2. CHECK VEHICLE SENSOR (OPERATION CHECK)

  1. E176549
    Enter the "Vehicle Sensors" screen. Refer to Check GPS & Vehicle Sensors in Operation Check (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check that these readings are almost equal.

    OK:
    The readings are almost equal.



NG
CHECK DTC OUTPUT (Click here)
OK


3. CHECK VEHICLE SIGNAL (OPERATION CHECK)
  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. E176550
    Check that the display changes between ON and OFF according to the shift lever operation.

    OK:
    Shift Lever Position
    Display
    Except R
    OFF
    R
    ON

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
GO TO "REVERSE SIGNAL DOES NOT CHANGE IN VEHICLE SIGNAL CHECK MODE" IN PROBLEM SYMPTOMS TABLE (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Poor Sound Quality in All Modes (Low Volume) (from Jul 2010)Vehicle Position Mark Deviates Greatly (from Jul 2012) →