HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the following procedures to troubleshoot the engine immobiliser system.
- Use the following procedures to troubleshoot the engine immobiliser system.
- The intelligent tester should be used in steps 5 and 7.
- The intelligent tester should be used in steps 5 and 7.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
- HINT:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- The following 5 items are important points in the problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Road conditions
Under what conditions?
Driving conditions, weather conditions
How did it happen?
Problem symptoms
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CRANK ENGINE FOR MORE THAN 10 SECONDS |
| |||||
| 5.CHECK FOR DTCS |
Check for DTCs and note any codes that are output (Click here).
Delete the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to duplicate the SFI system DTC, engine immobiliser system DTC, steering lock system DTC, or smart entry and start system (starting) DTC by simulating the symptoms indicated by the DTCs.
- Result:
Result
Proceed to
SFI system DTC output recurs
A
(Click here)
Engine immobiliser system DTC output recurs
B
(Click here)
Steering lock system DTC output recurs
C
(Click here)
Smart entry and start system (starting) DTC output recurs
D
(Click here)
DTC output does not recur
E
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is listed in problem symptoms table
A
Fault is not listed in problem symptoms table
B
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING |
DATA LIST/ACTIVE TEST (Click here)
TERMINALS OF ECU (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||