Check that the battery negative (-) cable is disconnected.
CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
Install the rear airbag sensor with the bolt and pin.
Torque:
9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
NOTICE:
If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Make sure that the pin is securely inserted into the body hole.
Tighten the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.
Check that there are no loose parts after installing the rear airbag sensor.
Connect the connector to the rear airbag sensor.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
2.
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
Engage the 4 clips and the 7 claws.
Install the 2 clips.
Install the deck trim side panel assembly LH with the 2 bolts.
3.
INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
Engage the 4 clips and the 7 claws.
Install the 2 clips.
Install the deck trim side panel assembly RH with the 3 bolts.
4.
INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY
Connect the floor anchor end of the rear No. 1 seat outer belt assembly and install the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
NOTICE:
Do not allow the anchor part of the rear No. 1 seat outer belt assembly to overlap the protruding part of the floor panel.
5.
INSTALL FRONT DECK SIDE TRIM COVER
Engage the 4 claws and install the 2 front deck side trim covers LH.
6.
INSTALL NO. 2 DECK SIDE TRIM HOOK (for LH Side)
Install the No. 2 deck side trim hook with the screw.
Engage the 2 guides and install the No. 2 deck board sub-assembly.
47.
INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Engage the 2 guides and install the No. 3 deck board sub-assembly.
48.
INSTALL DECK BOARD ASSEMBLY
Install the deck board sub-assembly.
49.
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
Align the alignment mark (red) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
NOTICE:
After installation, check that the corners fit correctly.
50.
INSTALL REAR DOOR SCUFF PLATE
Engage the guide, 3 clips and 5 claws, and install the rear door scuff plate LH.
51.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).