2007-2013 Highlander Kluger · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).


2. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side)

HINT:
Refer to the procedure up to Remove Front No. 2 Speaker Assembly (Click here).


3. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY

  1. C165103
    Disconnect the connector.


4. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
  1. Disconnect each connector.

  1. Remove the 2 passenger airbag bolts <A>.

  1. Disengage each clamp.

    B168376E01

  1. Remove the 2 clips.

  1. Remove the 2 bolts <D> and nut <G>.

  1. Disengage the 5 claws and remove the instrument panel safety pad assembly.

    B168377E03


5. REMOVE NO. 4 HEATER TO REGISTER DUCT

  1. B168379
    Remove the 3 screws <E> and the No. 4 heater to register duct.


6. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

  1. C165104
    Remove the 2 screws.

  1. C165105
    Disengage the 5 hooks.

  1. C165106
    Disengage the 5 hooks and remove the front passenger airbag assembly from the instrument panel safety pad assembly as shown in the illustration.


7. REMOVE INSTRUMENT PANEL WIRE ASSEMBLY

  1. C165107E01
    Disconnect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the clamp and instrument panel wire assembly from the front passenger airbag assembly.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →