2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Tachometer Malfunction

Circuit diagnosis · Vehicles built from Jul 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

In this circuit, the meter CPU receives engine revolution signals from the ECM using the CAN communication lines (CAN No. 1 Bus). The meter CPU displays engine revolution data that is calculated based on the data received from the ECM.

WIRING DIAGRAM

E143765E06

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication DTC is output (Click here).

    Result:
    Result
    Proceed to
    CAN communication DTC is not output.
    A
    CAN communication DTC is output.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Ignition switch on (IG).

  1. Turn the tester on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the operation by referring to the table below.

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Tacho Meter Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm)
    -

    OK:
    Needle indication is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3. READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Turn the tester on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. Check the values by referring to the table below.

    Combination Meter: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Rpm
    Engine speed/Min.: 0 rpm, Max.: 12750 rpm
    Almost same as actual engine speed (When engine is running)
    If data received from the ECM exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range.

    OK:
    Engine speed displayed on the tester is almost the same as the actual engine speed.



NG
Go to step 4
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)

4. READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Ignition switch on (IG).

  1. Turn the tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List.

  1. Check the values by referring to the table below.

    Engine and ECT: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed/Min.: 0 rpm, Max.: 16383.75 rpm
    Almost same as actual engine speed (When engine is running)
    -

    OK:
    Engine speed displayed on the tester is almost the same as the actual engine speed.



NG
GO TO SFI SYSTEM (Click here)
OK


5. REPLACE ECM
  1. Replace the ECM with a new or a normal one (Click here for 2GR-FE).

    OK:
    The operation of the tachometer returns to normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

END


← Tachometer Malfunction (Jul 2010 – Jun 2012)Fuel Receiver Gauge Malfunction (May 2007 – Jul 2008) →