2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The main body ECU (instrument panel junction block) receives switch signals from the door control switch and activates the door lock motor on each door according to these signals.

WIRING DIAGRAM

B171373E02

INSPECTION PROCEDURE


1. INSPECT DOOR CONTROL SWITCH ASSEMBLY (DOOR LOCK AND UNLOCK SWITCH)
  1. Remove the door control switch (Click here).

  1. B171374E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 3
    Locked
    Below 1 Ω
    4 - 3
    2 - 3
    OFF (Free)
    10 kΩ or higher
    2 - 3
    Unlocked
    Below 1 Ω



NG
REPLACE DOOR CONTROL SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (DOOR CONTROL SWITCH CIRCUIT)

  1. B171375E03
    Disconnect the instrument panel junction block connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for LHD:
    Tester Connection
    Condition
    Specified Condition
    G6-2 (UL) - 1J-4
    Always
    Below 1 Ω
    G6-4 (L) - 1J-3
    Always
    Below 1 Ω
    G6-3 (E) - Body ground
    Always
    Below 1 Ω
    G6-2 (UL) - Body ground
    Always
    10 kΩ or higher
    G6-4 (L) - Body ground
    Always
    10 kΩ or higher
    for RHD:
    Tester Connection
    Condition
    Specified Condition
    H9-2 (UL) - 1J-4
    Always
    Below 1 Ω
    H9-4 (L) - 1J-3
    Always
    Below 1 Ω
    H9-3 (E) - Body ground
    Always
    Below 1 Ω
    H9-2 (UL) - Body ground
    Always
    10 kΩ or higher
    H9-4 (L) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch, Driver Side Door Key Cylinder (from Jul 2010)All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch (Aug 2008 – Jun 2010) →