Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM
All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The main body ECU (instrument panel junction block) receives switch signals from the door control switch and activates the door lock motor on each door according to these signals. WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT DOOR CONTROL SWITCH ASSEMBLY (DOOR LOCK AND UNLOCK SWITCH)
Remove the door control switch (Click here ).
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Switch Condition
Specified Condition
4 - 3
Locked
Below 1 Ω
4 - 3 2 - 3
OFF (Free)
10 kΩ or higher
2 - 3
Unlocked
Below 1 Ω
NG
OK
2. CHECK HARNESS AND CONNECTOR (DOOR CONTROL SWITCH CIRCUIT)
Disconnect the instrument panel junction block connector.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
for LHD:
Tester Connection
Condition
Specified Condition
G6-2 (UL) - 1J-4
Always
Below 1 Ω
G6-4 (L) - 1J-3
Always
Below 1 Ω
G6-3 (E) - Body ground
Always
Below 1 Ω
G6-2 (UL) - Body ground
Always
10 kΩ or higher
G6-4 (L) - Body ground
Always
10 kΩ or higher
for RHD:
Tester Connection
Condition
Specified Condition
H9-2 (UL) - 1J-4
Always
Below 1 Ω
H9-4 (L) - 1J-3
Always
Below 1 Ω
H9-3 (E) - Body ground
Always
Below 1 Ω
H9-2 (UL) - Body ground
Always
10 kΩ or higher
H9-4 (L) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)