When the rear window defogger switch, which is built into the air conditioning control assembly, is operated, the operation signals are transmitted to the air conditioning amplifier assembly through LIN. When the air conditioning amplifier assembly receives the signals, it turns on the DEFOGGER relay (Marking: RR DEF) to operate the rear window defogger.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK FUSES (RR DEF)
Remove the fusible link block assembly (RR DEF) from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
A - B (RR DEF)
Always
Below 1 Ω
NG
REPLACE ENGINE ROOM JUNCTION BLOCK (RR DEF FUSE)
OK
2. INSPECT DEFOGGER RELAY (Marking: RR DEF)
Remove the defogger relay (Marking: RR DEF) from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
Standard resistance
Tester Connection
Condition
Specified Condition
3 - 4
Voltage is not applied between terminals 1 and 2
Below 1 Ω
3 - 4
Apply battery voltage between terminals 1 and 2
10 kΩ or higher
3 - 5
Voltage is not applied between terminals 1 and 2
10 kΩ or higher
3 - 5
Apply battery voltage between terminals 1 and 2
Below 1 Ω
NG
REPLACE DEFOGGER RELAY (Marking: RR DEF)
OK
3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
Select the ACTIVE TEST, use the intelligent tester to issue a control command, and then check the window defogger operation.
Air Conditioner:
Tester Display
Test Part
Control Range
Diagnostic Note
Defogger Relay (Rear)
Rear window defogger
OFF/ON
-
Result:
Result
Proceed to
The window defogger system does not operate normally when operating it through the intelligent tester.
A
The window defogger system operates normally when operating it through the intelligent tester.