FREEZE FRAME DATA
Troubleshooting · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| FREEZE FRAME DATA |
Whenever an ABS DTC is detected, the skid control ECU stores the current vehicle (sensor) state as Freeze Frame Data.
The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to on (IG) since the last time the ABS was activated.
- HINT:
- If the vehicle is stopped or at a low speed (7 km/h (4.3 mph) or less), or if a DTC is detected, the skid control ECU will stop counting the number.
- Freeze Frame Data at the time the ABS operates:
The skid control ECU stores and updates data whenever the ABS system operates.
When the ECU stores data at the time a DTC is detected, the data stored during ABS operation is erased.
- Freeze Frame Data at the time a DTC is detected:
When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.
- If the vehicle is stopped or at a low speed (7 km/h (4.3 mph) or less), or if a DTC is detected, the skid control ECU will stop counting the number.
| CHECK FREEZE FRAME DATA |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / DTC.
According to the display on the tester, select the DTC data display with Freeze Frame Data.
ABS / VSC / TRC: Tester Display
Measurement Item
Reference Value
Elapsed Time after Freeze Trigger
Elapsed time after freeze frame trigger
Min.: 0 ms, Max.: 500 ms
Number of IG ON
Number of operations of ignition switch being turned on (IG) after storing Freeze Frame Data
0 to 31
Buzzer
Skid control buzzer signal
Skid control buzzer ON: ON, OFF: OFF
Stop Light SW
Stop light switch signal
Stop light switch ON: ON, OFF: OFF
Parking Brake SW
Parking brake switch signal
Parking brake switch ON: ON, OFF: OFF
TRC (TRAC)/VSC OFF SW
VSC OFF switch signal
VSC OFF switch ON: OFF, OFF: ON
Gear Position
Gear position information
FAIL
1st
2nd
3rd
4th
5th
6th
7th
8th
P, N
R
NOT R
Shift Lever Position
Shift lever position information
FAIL
1st
2nd
3rd
4th
5th
6th/B
D/M
P, N
R
Operated System
Operated system status
ABS: ABS activated
VSC: VSC activated
TRC: TRC activated
BA: BA activated
HAB: HAB activated
HA-CTRL: Hill-start assist control activated
FAIL: Fail safe mode activated
SYS: System prohibit activated
NON: No operation activated
Master Cylinder Sensor
Master cylinder pressure sensor reading
Brake pedal released: 0.3 to 0.9 V
Brake pedal depressed: 0.8 to 4.5 V
M/C Sensor Grade
Master cylinder pressure sensor change
Min.: -30 MPa/s, Max.: 225 MPa/s
Yaw Rate Sensor
Yaw rate sensor reading
Min.: -128 deg/s, Max.: 127 deg/s
Lateral G
Lateral G
Min.: -25.11 m/s2, Max.: 24.91 m/s2
Forward and Rearward G
Forward and backward G
Min.: -25.11 m/s2, Max.: 24.91 m/s2
FR Wheel Speed
FR wheel speed
Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
FL Wheel Speed
FL wheel speed
Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
RR Wheel Speed
RR wheel speed
Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
RL Wheel Speed
RL wheel speed
Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
Vehicle Speed
Vehicle speed reading
Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
Vehicle Speed Grade
Vehicle speed grade
Min.: -25.11 m/s2, Max.: 24.91 m/s2
Real Engine Torque
Real engine torque
Min.: -1024 Nm, Max.: 1023 Nm
Accelerator Opening Angle %
Accelerator opening Angle %
Min.: 0 %, Max.: 128 %
Brake Pedal Load Sensing SW
Brake pedal load sensing switch signal
Brake pedal load sensing switch ON: ON, OFF: OFF
Inspection Mode
Inspection mode
OTHER: Normal mode
INSPECT: Inspection mode
Steering Angle Sensor
Steering angle sensor reading
Left turn: Increase
Right turn: Decrease
TRC/VSC Off Mode
TRC/VSC off mode
NORMAL: Normal mode
TRC OFF: TRC off mode
VSC OFF: VSC off mode
| CLEAR FREEZE FRAME DATA |
- NOTICE:
- Clearing the DTCs will also clear the Freeze Frame Data.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Clear the DTCs and Freeze Frame Data (Click here).