2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH

  1. B172795
    Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.

  1. B172796
    Peel off the double-sided tape and disengage the 3 clips, and then remove the front fender moulding sub-assembly.

  1. Remove the pad from the front fender moulding sub-assembly.

  1. Remove the 2 No. 4 clips from the front fender moulding sub-assembly.

  1. B172797E02
    Remove the double-sided tape from the front fender moulding sub-assembly.
    Text in Illustration 
    *1
    Double-sided Tape


2. REMOVE FRONT FENDER LINER LH

  1. B258289E01
    Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

  1. B260029
    Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 3 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

  1. B260027
    Remove the 5 clips.

  1. Remove the bolt, 8 screws and front fender liner LH.


3. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B258270
    Remove the 11 clips and cool air intake duct seal.


4. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

  1. B258273E01
    Put protective tape around the radiator grille sub-assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. B258271
    Remove the 6 clips.

  1. Disengage the 8 claws and 2 guides, and remove the radiator grille sub-assembly.


5. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

  1. B174188
    Remove the hood lock nut cap.

  1. B174189
    Remove the 3 bolts.

  1. B174190
    Disconnect the hood lock control cable and remove the hood lock assembly.


6. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

  1. B174191
    Disconnect the connector.

  1. B174192
    Remove the hood lock nut cap.

  1. B174193
    Remove the 3 bolts.

  1. B174194
    Disconnect the hood lock control cable and remove the hood lock assembly.


7. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

  1. B174196
    Disconnect the hood lock control cable from the hood lock control lever.

  1. Using a screwdriver, disconnect the clamps shown in the illustration.

    B174195E01

    Area
    Part Name
    Area
    Part Name
    A
    Hood lock control cable
    E
    Fender liner
    B
    Clamp
    F
    Hood stopper rubber
    C
    Hood cable grommet
    G
    Front washer hose
    D
    Wire harness
    H
    Rear washer hose

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the cable from the engine compartment and remove it.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →