HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jul 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
- HINT:
- Use the following procedure to troubleshoot the push-button start function.
- *: Use the intelligent tester.
- Use the following procedure to troubleshoot the push-button start function.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
- HINT:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- The following 5 items are important points in the problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Road conditions
Under what conditions?
Running conditions, driving conditions, weather conditions
How did it happen?
Problem symptoms
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN Communication System is functioning normally (Click here).
- Result:
Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Delete DTCs.
Recheck for DTCs.
- Result:
Result
Proceed to
DTC does not reoccur
A
DTC reoccurs
B
|
|||||
| |||||
| 6.INSPECT BASIC OPERATION |
Turn the engine switch on (START) and check that the engine starts normally. Make sure that the brake pedal is depressed and the shift position is P at this time.
Check that the engine switch mode can be changed by pushing the engine switch.
- HINT:
- Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off.
- With the brake pedal depressed, push the engine switch. Engine switch mode should turn to ENGINE START from any status.
- OK:
- Engine starts normally.
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is not listed in the problem symptoms table
A
Fault is listed in the problem symptoms table
B
|
|||||
| |||||
| 8.OVERALL ANALYSIS AND TROUBLESHOOTING* |
TERMINALS OF ECU (Click here).
DATA LIST/ACTIVE TEST (Click here).
| |||||
| 9.REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
| |||||