2007-2013 Highlander Kluger · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSTALL PLANETARY GEAR

  1. A081656E01
    Apply grease to the planetary gears and pin parts of the planetary shaft.

  1. Install the 3 planetary gears.


2. INSTALL STARTER ARMATURE ASSEMBLY

  1. A082440E01
    Apply grease to the plate washer and the armature shaft.

  1. Install the starter armature assembly to the starter commutator end frame assembly.

  1. Using snap ring pliers, install the plate washer and a new snap ring.

    NOTICE:
    1. Be sure to install the snap ring in the armature shaft groove securely.
    2. Be sure to properly install the snap ring because it easily expands.

  1. A058810E19
    Using a vernier caliper, measure the length of the snap ring.

    Maximum length:
    5.0 mm (0.197 in.)

    If the length is greater than the maximum, replace it with a new snap ring.


3. INSTALL STARTER COMMUTATOR END FRAME COVER

  1. A081178
    Install the starter commutator end frame cover to the starter commutator end frame assembly.


4. INSTALL STARTER ARMATURE PLATE

  1. A073991E04
    Insert the armature plate to the starter yoke assembly.

  1. Align the keyway of the starter armature plate with the key inside the starter yoke assembly, and install the starter armature plate.


5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY

  1. A079727E01
    Align the rubber of the end frame with the cutout of the starter yoke assembly.

  1. Install the starter commutator end frame to the starter yoke assembly.

    NOTICE:
    The magnet of the starter yoke assembly may attract the starter armature assembly when the starter commutator end frame assembly is installed, causing the magnet to break.


6. INSTALL STARTER YOKE ASSEMBLY

  1. A079728E01
    Align the protrusion of the starter yoke with the cutout of the motor terminal starter kit.

  1. A079720
    Install the starter yoke with the 2 through-bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


7. INSTALL REPAIR SERVICE STARTER KIT

  1. A079729
    Apply grease to the plunger and the hook.

  1. Hang the plunger hook of the repair service starter kit to the drive lever hook.

  1. Install the plunger and return spring.

  1. A079719
    Install the repair service starter kit with the 2 screws.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. A079718
    Connect the lead wire to terminal C with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

← INSPECTION (from May 2007)INSTALLATION (May 2007 – Jul 2008) →