C1437 Lost Communication with ECM
Diagnostic trouble codes · Vehicles built Jul 2010 – Jun 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
The skid control ECU receives signals from the ECM via the CAN communication system.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1437 |
When the IG1 terminal voltage is 10 V or more and the vehicle speed is 15 km/h (9 mph) or more, data cannot be sent to the ECM for 2 seconds or more. |
|
WIRING DIAGRAM
Refer to DTCs U0073, U0100, U0123, U0124 and U0126 (Click here).INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION) |
Using the intelligent tester, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).
ABS / VSC / TRC: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
EFI Communication Open
EFI communication open detection / Error or Normal
Error: Momentary interruption
Normal: Normal
-
- OK:
- There are no momentary interruptions.
- HINT:
- Perform the above inspection before removing the sensor and connector.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is recorded (Click here).
- Result:
Result
Proceed to
DTC (C1437) is not output
A
DTC (C1437) is output
B
DTC (CAN communication system DTC) is output
C
|
|
||||
|
|
||||
| A | ||
| ||
| 3. REPAIR OR REPLACE HARNESS OR CONNECTOR (SKID CONTROL ECU - ECM) |
Turn the ignition switch off.
Repair or replace the harness or connector.
Check for any momentary interruption between the skid control ECU and the ECM (Click here).
Check that there is no momentary interruption.
| NEXT | |
| 4. RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is recorded (Click here).
- Result:
Result
Proceed to
DTC (C1437) is not output
A
DTC (C1437) is output
B
DTC (CAN communication system DTC) is output
C
|
|
||||
|
|
||||
| A | ||
| ||
