2007-2013 Highlander Kluger · Service Manual BRAKE

C1437 Lost Communication with ECM

Diagnostic trouble codes · Vehicles built from Jul 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

The skid control ECU receives signals from the ECM via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
C1437
When the IG1 terminal voltage is 10 V or more and the vehicle speed is 15 km/h (9 mph) or more, data cannot be sent to the ECM for 2 seconds or more.
  1. CAN communication system (Skid control ECU to ECM)
  2. Brake actuator assembly (Skid control ECU)

WIRING DIAGRAM

Refer to DTCs U0073, U0100, U0123, U0124 and U0126 (Click here).

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)
  1. Using the intelligent tester, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).

    ABS / VSC / TRC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    EFI Communication Open
    EFI communication open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -

    OK:
    There are no momentary interruptions.

    HINT:
    Perform the above inspection before removing the sensor and connector.



NG
Go to step 3
OK


2. RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.

  1. Check that no CAN communication system DTC is output (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC (C1437) is not output
    A
    DTC (C1437) is output
    B
    DTC (CAN communication system DTC) is output
    C



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

C
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)

3. REPAIR OR REPLACE HARNESS OR CONNECTOR (SKID CONTROL ECU - ECM)
  1. Turn the ignition switch off.

  1. Repair or replace the harness or connector.

  1. Check for any momentary interruption between the skid control ECU and the ECM (Click here).

  1. Check that there is no momentary interruption.


NEXT


4. RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.

  1. Check that no CAN communication system DTC is output (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC (C1437) is not output
    A
    DTC (C1437) is output
    B
    DTC (CAN communication system DTC) is output
    C



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

C
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A

END


← C1437 Lost Communication with ECM (Jul 2010 – Jun 2012)C1439 Steering Angle Sensor Initialization Incomplete (+ C1445) (Aug 2008 – Jun 2010) →