2007-2013 Highlander Kluger · Service Manual CRUISE CONTROL SYSTEM

P0500 Vehicle Speed Sensor Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Refer to DTC P0500 (Click here).
DTC No.
DTC Detection Condition
Trouble Area
P0500
The vehicle speed signal from the vehicle speed sensor is cut for 0.14 sec. or more while cruise control is operating.
  1. Vehicle speed sensor
  2. Vehicle speed signal circuit
  3. Combination meter assembly
  4. ECM

WIRING DIAGRAM

Refer to DTC P0500 (Click here).

INSPECTION PROCEDURE

This DTC may be output by the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.

1. READ OUTPUT DTC (DTC P0500)
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    OK
    DTC P0500 is output
    NG



NG
GO TO SFI SYSTEM (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← P0500 Vehicle Speed Sensor Malfunction (+ P0503) (Aug 2008 – Jun 2010)P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High (from Jul 2010) →