2007-2013 Highlander Kluger · Service Manual CRUISE CONTROL SYSTEM

P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High

Diagnostic trouble codes · Vehicles built from Jul 2010

DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while the cruise control is operating, the ECM determines that there is a momentary interruption or noise, and outputs a DTC.
DTC No.
DTC Detection Condition
Trouble Area
P0503
Momentary interruption and noise are detected when a rapid change of the vehicle speed occurs while cruise control is operating.
  1. Vehicle speed sensor
  2. Vehicle speed sensor signal circuit
  3. Combination meter assembly
  4. ECM

WIRING DIAGRAM

E190390E11

INSPECTION PROCEDURE

This DTC may be output by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.

1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.

  1. Check DTCs for vehicle stability control system (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    OK
    DTC is output
    NG



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART) (Click here)
OK


2. REPLACE COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly (Click here).


NEXT


3. CHECK DTC (CRUISE CONTROL SYSTEM)
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed of 40 km/h (25 mph) or more.

    2. Turn the cruise control main switch on.

    3. Push the -SET switch to activate the cruise control.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    OK
    DTC P0503 is output
    NG



NG
REPLACE ECM (Click here)
OK

END


← P0500 Vehicle Speed Sensor Malfunction (from Jul 2010)P0571 Brake Switch "A" Circuit (May 2007 – Jul 2008) →