2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jul 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

HINT:
The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
Use this procedure to troubleshoot the wireless door lock control system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).

    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use the intelligent tester to check for normal function of the can communication system.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B


    B.
    A

    4.DTC CHECK
    1. Check for a DTC and note any codes that are output.

    2. Delete the DTC.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original symptom that the DTC suggests.

      Result:
      Result
      Proceed to
      DTC does not recur
      A
      DTC recurs
      B


    B.
    A

    5.SYMPTOM SIMULATION
      NEXT

      6.PROBLEM SYMPTOMS TABLE
      1. If the fault is not listed in the problem symptoms table, proceed to A.

      2. If the fault is listed in the problem symptoms table, proceed to B.


      B.
      A

      7.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
      1. Terminals of ECU (Click here)

      2. DATA LIST/ACTIVE TEST (Click here)

      NEXT

      8.ADJUST, REPAIR OR REPLACE
        NEXT

        9.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Jul 2010 – Jun 2012)OPERATION CHECK (May 2007 – Jun 2010) →