2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Jul 2012

Versions by build date: Jul 2010 – Jun 2012 from Jul 2012


NAVIGATION RECEIVER ASSEMBLY
E210034E01
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
E6-1 (FR+) - E6-7 (GND)
LG - BR
Sound signal (Front right)
Audio system playing
A waveform synchronized with sounds is output
E6-2 (FL+) - E6-7 (GND)
P - BR
Sound signal (Front left)
Audio system playing
A waveform synchronized with sounds is output
E6-3 (ACC) - E6-7 (GND)
GR - BR
Accessory (ON)
Ignition switch off
Below 1 V
Ignition switch ACC
11 to 14 V
E6-4 (B) - E6-7 (GND)
B - BR
Battery
Ignition switch off
11 to 14 V
E6-5 (FR-) - E6-7 (GND)
L - BR
Sound signal (Front right)
Audio system playing
A waveform synchronized with sounds is output
E6-6 (FL-) - E6-7 (GND)
V - BR
Sound signal (Front left)
Audio system playing
A waveform synchronized with sounds is output
E6-7 (GND) - Body ground
BR - Body ground
Ground
Always
Below 1 V
E6-10 (ILL+) - E6-7 (GND)
G - BR
Illumination signal
Ignition switch ON
Light control switch off → tail or on
Below 1 V → 11 to 14 V
E7-1 (RR+) - E6-7 (GND)
R - BR
Sound signal (Rear right)
Audio system playing
A waveform synchronized with sounds is output
E7-2 (RL+) - E6-7 (GND)
B - BR
Sound signal (Rear left)
Audio system playing
A waveform synchronized with sounds is output
E7-3 (RR-) - E6-7 (GND)
W - BR
Sound signal (Rear right)
Audio system playing
A waveform synchronized with sounds is output
E7-6 (RL-) - E6-7 (GND)
Y - BR
Sound signal (Rear left)
Audio system playing
A waveform synchronized with sounds is output
E2-1 (V+) - E6-7 (GND)
R - BR
Television camera image signal
Ignition switch ON
Shift lever in R
Camera lens is not covered, displaying an image
Pulse generation (Refer to waveform 1)
Ignition switch ON
Shift lever in R
Camera lens is covered, blacking out screen
Pulse generation (Refer to waveform 2)
E2-2 (CA+) - E6-7 (GND)
B - BR
Television camera power supply
Ignition switch ON
Shift lever in R
5.5 to 7 V
E2-3 (SNS2) - E6-7 (GND)
G - BR
Microphone connection detection signal
Always
Below 1 V
E2-4 (MIN+) - E6-7 (GND)
B - BR
Microphone voice signal
See "Microphone & Voice Recognition Check" in Operation Check (Click here)
-
E2-5 (MACC) - E6-7 (GND)
W - BR
Telephone microphone assembly power supply
Ignition switch off
Below 1 V
Ignition switch ACC
4 to 6 V
E2-6 (SWG) - Body ground
B - Body ground
Steering pad switch signal
Always
Below 1 V
E2-7 (SW1) - E2-6 (SWG)
BE - B
Steering pad switch signal
No switch pushed →
MODE switch pushed →
ON HOOK switch pushed →
OFF HOOK switch pushed →
VOICE switch pushed
4.44 to 5.43 V →
0.45 to 0.65 V →
1.19 to 1.49 V →
2.09 to 2.54 V →
3.2 to 3.88V
E2-8 (SW2) - E2-6 (SWG)
V - B
Steering pad switch signal
No switch is pushed →
SEEK+ switch pushed →
SEEK- switch pushed →
VOL+ switch pushed →
VOL- switch pushedd
4.44 to 5.43 V →
0.45 to 0.65 V →
1.19 to 1.49 V →
2.09 to 2.54 V →
3.2 to 3.88 V
E2-11 (V-) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
E2-12 (CGND) - E6-7 (GND)
W - BR
Ground
Always
Below 1 V
E2-13 (MIN-) - Body ground
R - Body ground
Microphone voice signal
See "Microphone & Voice Recognition Check" in Operation Check (Click here)
-
E2-14 (SGND) - E6-7 (GND)
Shield - BR
Shield ground
Always
Below 1 V
E2-15 (ARI) - E2-16 (ASGN)
R - W
Sound signal (Right)
External device playing (When stereo jack used)
A waveform synchronized with sounds is output
E2-16 (ASGN) - E6-7 (GND)
W - BR
Sound signal ground
Always
Below 1 V
E2-17 (ALI) - E2-16 (ASGN)
B - W
Sound signal (Left)
External device playing (When stereo jack used)
A waveform synchronized with sounds is output
E2-18 (AGND) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
E2-19 (AUXI) - E6-7 (GND)
Y - BR
External device connection detection signal
External device connected
Below 1 V
External device not connected
2.1 to 3 V
E4-1 (PKB) - E6-7 (GND)
LG - BR
Parking brake signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
E4-2 (IG) - E6-7 (GND)
G - BR
Power source (IG)
Ignition switch off
Below 1 V
Ignition switch ON
11 to 14 V
E4-3 (SPD) - E6-7 (GND)
V - BR
Speed signal from combination meter assembly
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
E4-5 (REV) - E6-7 (GND)
R - BR
Reverse signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
E23-1 (CSLD) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
E23-2 (CDR+) - E6-7 (GND)
BR - BR
USB audio system sound signal
USB audio system playing
A waveform synchronized with sounds is output
E23-3 (CDR-) - E6-7 (GND)
SB - BR
USB audio system sound signal
USB audio system playing
A waveform synchronized with sounds is output
E23-4 (CDL+) - E6-7 (GND)
LG - BR
USB audio system sound signal
USB audio system playing
A waveform synchronized with sounds is output
E23-5 (CDL-) - E6-7 (GND)
P - BR
USB audio system sound signal
USB audio system playing
A waveform synchronized with sounds is output
E23-6 (MUTE) - E6-7 (GND)
B- BR
Mute signal
USB audio system playing → Source changed to CD
Above 3.5 V → Below 1 V
E23-7 (GND) - Body ground
L - Body ground
Ground
Always
Below 1 V
E23-9 (TXM+)
Y
AVC-LAN communication signal
-
-
E23-10 (TXM-)
V
AVC-LAN communication signal
-
-
E23-11 (ACC) - E6-7 (GND)
G - BR
Accessory (ON)
Ignition switch off
Below 1 V
Ignition switch ACC
11 to 14 V
E23-12 (+B) - E6-7 (GND)
SB - BR
Battery
Ignition switch off
11 to 14 V
RA-5 (ANT) - E6-7 (GND)
- - BR
Power source of antenna
Ignition switch ON
Radio switch on and AM or FM selected
8 V or higher

  1. E171712E20
    Reference (Oscilloscope waveform):

    1. Waveform 1 (camera lens is not covered, displaying an image)

      Item
      Content
      Measurement terminal
      E2-1 (V+) - E6-7 (GND)
      Measurement setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Ignition switch ON, Shift lever in R

      HINT:
      The video waveform changes according to the image sent by the television camera assembly.

    2. Waveform 2 (camera lens is covered, blacking out the screen)

      Item
      Content
      Measurement terminal
      E2-1 (V+) - E6-7 (GND)
      Measurement setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Ignition switch ON, Shift lever in R

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

      Text in Illustration 
      *a
      Waveform 1 (camera lens not covered, displaying an image)
      *b
      Waveform 2 (camera lens covered, blacking out the screen)
      *c
      Synchronization Signal
      *d
      Video Waveform


MULTI-MEDIA INTERFACE ECU
E210147E01
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specification
E25-1 (USD1) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
E25-2 (URO+) - E25-7 (GND)
BR - L
USB audio system sound signal
USB audio system playing
A waveform synchronized with sounds is output
E25-3 (URO-) - E25-7 (GND)
SB - L
USB audio system sound signal
USB audio system playing
A waveform synchronized with sounds is output
E25-4 (ULO+) - E25-7 (GND)
LG - L
USB audio system sound signal
USB audio system playing
A waveform synchronized with sounds is output
E25-5 (ULO-) - E25-7 (GND)
P - L
USB audio system sound signal
USB audio system playing
A waveform synchronized with sounds is output
E25-6 (MUT1) - E25-7 (GND)
B - L
Mute signal
USB audio system playing → Source changed to CD
Above 3.5 V → Below 1 V
E25-7 (GND) - Body ground
L - Body ground
Ground
Always
Below 1 V
E25-9 (TX1+)
Y
AVC-LAN communication signal
-
-
E25-10 (TX1-)
V
AVC-LAN communication signal
-
-
E25-11 (ACC) - E25-7 (GND)
G - L
Accessory (ON)
Ignition switch off
Below 1 V
Ignition switch ACC
11 to 14 V
E25-12 (+B) - E25-7 (GND)
SB - L
Battery
Ignition switch off
11 to 14 V
E28-1 (UESG) - Body ground
- - Body ground
Ground
Always
Below 1 V
E28-2 (UDI+) - E28-1 (UESG)
-
Data signal
USB device or "iPod" connected
-
E28-3 (UDI-) - E28-1 (UESG)
-
Data signal
USB device or "iPod" connected
-
E28-4 (UPO) - E28-1 (UESG)
-
USB device or "iPod" power supply
Ignition switch ACC
5 V
E28-5 (UESS) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
← TERMINALS OF ECU (Jul 2010 – Jun 2012)DTC CHECK / CLEAR (from Jul 2010) →