2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT FRONT STABILIZER LINK ASSEMBLY

  1. C066721
    Inspect the turning torque of the ball joint.

    1. Secure the front stabilizer link assembly in a vise using aluminum plates.

    2. Install the nut to the front stabilizer link assembly stud.

    3. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

      Turning torque:
      0.05 to 1.96 N*m (0.5 to 20 kgf*cm, 0.4 to 17 in.*lbf)

      If the turning torque is not within the specified range, replace the front stabilizer link assembly with a new one.

  1. Inspect the dust cover.

    1. Check that the dust cover is not cracked and that there is no grease on it.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →