2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE DECK BOARD ASSEMBLY

  1. B173240
    Remove the deck board assembly.


2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Tonneau Cover)

  1. B173242
    Disengage the 2 guides and remove the No. 3 deck board sub-assembly.


3. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Tonneau Cover)

  1. B173244
    Disengage the 2 guides and remove the No. 2 deck board sub-assembly.


4. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
  1. Remove the tonneau cover assembly.


5. REMOVE REAR MAT

  1. B173249
    Remove the rear mat.


6. REMOVE DECK TRIM SERVICE HOLE COVER

7. REMOVE LOWER SPARE WHEEL CARRIER HINGE COVER

8. REMOVE SPARE TIRE

9. REMOVE SPARE WHEEL CARRIER LOCK COVER

10. REMOVE REAR WHEEL

11. SEPARATE REAR STABILIZER LINK ASSEMBLY LH

  1. C167797E01
    Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.


12. SEPARATE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.


13. REMOVE REAR STABILIZER BAR

  1. C170677E01
    Remove the 4 bolts and rear stabilizer bar.


14. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY

C167804
  1. Remove the bolt and the nut, and separate the rear No. 2 suspension arm assembly from the rear axle carrier sub-assembly.

    NOTICE:
    Since a stopper nut is used, loosen the bolt.

  1. Remove the bolt and the rear No. 2 suspension arm assembly.


15. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY

C167805
  1. Remove the bolt and the nut, and separate the rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly.

    NOTICE:
    Since a stopper nut is used, loosen the bolt.

  1. Remove the bolt and the rear No. 1 suspension arm assembly.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →