2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Steering Pad Switch Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This circuit sends an operation signal from the steering pad switch to the navigation receiver assembly.
If there is an open in the circuit, the navigation system cannot be operated using the steering pad switch.
If there is a short in the circuit, the resulting condition is the same as to if the switch were continuously pressed. Therefore, the navigation receiver assembly cannot be operated using the steering pad switch, and the navigation receiver assembly itself cannot function.

WIRING DIAGRAM

E150779E03

INSPECTION PROCEDURE

NOTICE:
The vehicle is equipped with an SRS (Supplemental Restraint System). Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the Supplemental Restraint System (Click here).


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E141020E13
    Disconnect navigation receiver assembly connector E2.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E2-7 (SW1) - E2-6 (SWG)
    No switch is pushed
    Approx. 100 kΩ
    E2-7 (SW1) - E2-6 (SWG)
    SEEK+ switch: pushed
    0 to 2.5 Ω
    E2-7 (SW1) - E2-6 (SWG)
    SEEK- switch: pushed
    Approx. 0.3 kΩ
    E2-7 (SW1) - E2-6 (SWG)
    VOL+ switch: pushed
    Approx. 1 kΩ
    E2-7 (SW1) - E2-6 (SWG)
    VOL- switch: pushed
    Approx. 3.1 kΩ
    E2-8 (SW2) - E2-6 (SWG)
    No switch is pushed
    Approx. 100 kΩ
    E2-8 (SW2) - E2-6 (SWG)
    MODE switch: pushed
    0 to 2.5 Ω
    E2-8 (SW2) - E2-6 (SWG)
    VOICE switch: pushed
    Approx. 3.1 kΩ
    E2-8 (SW2) - E2-6 (SWG)
    ON HOOK switch: pushed
    Approx. 0.3 kΩ
    E2-8 (SW2) - E2-6 (SWG)
    OFF HOOK switch: pushed
    Approx. 1 kΩ



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT SPIRAL CABLE

  1. E150780E05
    Disconnect the steering pad switch and spiral cable connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    z2-8 (EAU) - D53-4 (EAU)
    Center
    Below 1 Ω
    2.5 rotations to the left
    2.5 rotations to the right
    z2-10 (AU1) - D53-6 (AU1)
    Center
    Below 1 Ω
    2.5 rotations to the left
    2.5 rotations to the right
    z2-9 (AU2) - D53-5 (AU2)
    Center
    Below 1 Ω
    2.5 rotations to the left
    2.5 rotations to the right

    NOTICE:
    The spiral cable is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable may prevent the airbag from deploying. Refer to the pages shown in the brackets.

    HINT:
    1. REMOVAL (Click here)
    2. INSTALLATION (Click here)



NG
REPLACE SPIRAL CABLE
OK


3. INSPECT STEERING PAD SWITCH ASSEMBLY

  1. Disconnect steering pad switch assembly connector z2.E136177E07

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    z2-10 (AU1) - z2-8 (EAU)
    No switch is pushed
    Approx. 100 kΩ
    z2-10 (AU1) - z2-8 (EAU)
    SEEK+ switch: pushed
    0 to 2.5 Ω
    z2-10 (AU1) - z2-8 (EAU)
    SEEK- switch: pushed
    Approx. 0.3 kΩ
    z2-10 (AU1) - z2-8 (EAU)
    VOL+ switch: pushed
    Approx. 1 kΩ
    z2-10 (AU1) - z2-8 (EAU)
    VOL- switch: pushed
    Approx. 3.1 kΩ
    z2-9 (AU2) - z2-8 (EAU)
    No switch is pushed
    Approx. 100 kΩ
    z2-9 (AU2) - z2-8 (EAU)
    MODE switch: pushed
    0 to 2.5 Ω
    z2-9 (AU2) - z2-8 (EAU)
    VOICE switch: push
    Approx. 3.1 kΩ
    z2-9 (AU2) - z2-8 (EAU)
    ON HOOK switch: pushed
    Approx. 0.3 kΩ
    z2-9 (AU2) - z2-8 (EAU)
    OFF HOOK switch: pushed
    Approx. 1 kΩ



NG
REPLACE STEERING PAD SWITCH ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - SPIRAL CABLE)


← Steering Pad Switch Circuit (May 2007 – Jul 2008)Steering Pad Switch Circuit (from Jul 2010) →