2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Entire Combination Meter does not Operate

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This circuit is the power source circuit for the meter. This circuit provides two types of power sources; one is a constant power source mainly used as a backup power source, and the other is an IG power source mainly used for signal transmission. The constant power source is mainly used as a backup power source of the meter CPU, however, it is also used for CAN communication. If a voltage of 12 V is not applied to terminal IG+ when the ignition switch is on (IG), the indicator will not operate.

WIRING DIAGRAM

E146954E02

INSPECTION PROCEDURE


1. INSPECT COMBINATION METER ASSEMBLY

  1. E146920E01
    Disconnect the E1 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-20 (ES) - Body ground
    Always
    Below 1 Ω
    E1-40 (E2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E1-1 (IG+) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    E1-21 (B) - Body ground
    Always
    10 to 14 V
    E1-22 (B2) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Entire Combination Meter does not Operate (Aug 2008 – Jun 2010)Speedometer Malfunction (May 2007 – Jul 2008) →