2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT A/C PRESSURE SENSOR
  1. Install the manifold gauge set.

  1. Disconnect the connector from the A/C pressure sensor.

  1. E107326E13
    Connect the three 1.5 V dry cell batteries' positive (+) lead to terminal 3 and the negative (-) lead to terminal 1.

  1. Connect the voltmeter's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    2 - 1
    Refrigerant pressure:
    0.39 to 3.187 MPa (57 to 463 psi)
    1.0 to 4.8 V

    If the result is not as specified, replace the A/C pressure sensor.

← INSTALLATION (from Jul 2010)ON-VEHICLE INSPECTION (May 2007 – Jul 2008) →