HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the following procedure to troubleshoot the rear view monitor system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.CUSTOMER PROBLEM ANALYSIS |
| NEXT |
|
 |
|
|
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage with the ignition switch off.
- Standard Voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| NEXT |
|
 |
|
|
| 4.PROBLEM SYMPTOM CONFIRMATION |
- Result:
Result
|
Proceed to
|
Symptom does not occur
|
A
|
Symptom occurs
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| NEXT |
|
 |
|
|
| 6.CHECK FOR NAVIGATION SYSTEM DTC |
Check for Navigation System DTCs.
- HINT:
- w/ Navigation System (for DVD) (Click here)
- w/ Navigation System (for HDD) (Click here)
- Result:
Result
|
Proceed to
|
DTCs are not output
|
A
|
DTCs are output (w/ Navigation System (for DVD))
|
B
|
DTCs are output (w/ Navigation System (for HDD))
|
C
|
| 7.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM |
Refer to Navigation System.
- HINT:
- w/ Navigation System (for DVD) (Click here)
- w/ Navigation System (for HDD) (Click here)
- Result:
Result
|
Proceed to
|
Symptom does not appear
|
A
|
Symptom appears
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Refer to Problem Symptoms Table (Click here).
- Result:
Result
|
Proceed to
|
Fault is not listed in Problem Symptoms Table
|
A
|
Fault is listed in Problem Symptoms Table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 9.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM |
Refer to Terminals of ECU (Click here).
| NEXT |
|
 |
|
|
| 10.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|