2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK CELLULAR PHONE
  1. Check if the other side can hear your voice correctly.

    OK:
    Your voice can be heard correctly.



NG
REPLACE CELLULAR PHONE
OK


2. CHECK SETTINGS

  1. E120109E03
    Check if the mute switch is set to ON.

    OK:
    Mute switch is not set to ON.



NG
TURN MUTE SWITCH OFF
OK


3. CHECK SETTINGS

  1. E120069E06
    Enter the "Handsfree Voice Quality Set" mode (Click here).

  1. Check if the Send Voice Level is set to "0".

    HINT:
    The Send Voice Level can be set to 11 different levels, -5 to +5, with a 3 dB difference.

  1. Check if the Send Voice Level is set to the minimum or maximum level.

    HINT:
    When the Send Voice Level is set to the minimum or maximum level, the sound may be distorted.

    OK:
    The Send Voice Level is set to "0".



NG
SET SEND VOICE LEVEL TO "0"
OK


4. CHECK MICROPHONE (NAVIGATION CHECK MODE)

  1. E120056E03
    Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted (from Jul 2012)The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted (Aug 2008 – Jun 2010) →