01-D5 Absence of Registration Unit
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Also covers:
- 01-D8 No Response for Connection Check
- 01-D9 Last Mode Error
- 01-DA No Response Against ON / OFF Command
- 01-DB Mode Status Error
- 01-DE Slave Reset
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010
DESCRIPTION
| DTC No. |
DTC Detection Condition |
Trouble Area |
| 01-D5 *1, *3 |
|
|
| 01-D8 *2, *3 |
A component shown by the sub-code is (was) disconnected from the system after the engine starts. |
|
| 01-D9 *1, *3 |
The device that had functioned before the engine stopped is (was) disconnected from the system while the ignition switch is (was) on (IG or ACC). |
|
| 01-DA *3 |
|
|
| 01-DB *1, *3 |
A dual alarm is detected. |
|
| 01-DE *3, *4 |
A slave device has been disconnected after the engine starts. |
- HINT:
- *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.
- *2: If the power connector is disconnected after the engine starts, this code is stored after 180 seconds.
- *3: If it is reported that the device does not exist during verification, check the power source circuit and AVC-LAN circuit for the device.
- *4: This code may be stored if the engine is started and then started again.
- *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.
- NOTICE:
- Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The navigation receiver assembly is the master unit.
- Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.
- Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
INSPECTION PROCEDURE
- NOTICE:
- Be sure to read DESCRIPTION before performing the following procedures.
| 1. CHECK "NAVIGATION RECEIVER ASSEMBLY COMMUNICATION ERROR" IN FLOW CHART |
| NEXT | ||
| ||
