2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Navigation Receiver Assembly Communication Error

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

INSPECTION PROCEDURE


1. IDENTIFY THE COMPONENT SHOWN BY SUB-CODE

  1. E136189E16
    Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change the mode to "LAN Monitor" mode.

  1. Identify the component shown by the sub-code.

    HINT:
    1. "110 (multi-display)" is the component shown by the sub-code in the example shown in the illustration.
    2. The sub-code will be indicated by its physical address.
    3. For the component list, refer to "DIAGNOSIS DISPLAY DETAILED DESCRIPTION" (Click here).


NEXT


2. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.If the power source circuit is operating normally, proceed to the next step.

    Component Table: 
    Component
    Proceed to
    1AC (Television camera ECU)
    Television camera ECU power source circuit (Click here)


NEXT


3. CHECK NAVIGATION RECEIVER ASSEMBLY

  1. E153731E01
    Disconnect navigation receiver assembly connector E2.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-9 (TX+) - E2-10 (TX-)
    Always
    60 to 80 Ω



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to "TERMINALS OF ECU" (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver assembly and the component shown by the sub-code.

    1. Disconnect all connectors between the navigation receiver assembly and the component shown by the sub-code.

    2. Check for an open or short in the AVC-LAN circuit between the navigation receiver assembly and the component shown by the sub-code.E153704E01

      OK:
      There are no open or short circuits.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END


← Navigation Receiver Assembly Power Source Circuit (from Jul 2010)Navigation Receiver Assembly Communication Error (Aug 2008 – Jun 2010) →