2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

01-D5 Absence of Registration Unit

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
01-D5
*1, *3
  1. A component shown by the sub-code is (was) disconnected from the system while the ignition switch is (was) on (IG or ACC).
  2. The communication condition with the device that the code shows cannot be obtained when the engine starts.
  1. Power source circuit of the component shown by the sub-code
  1. AVC-LAN circuit between the navigation receiver assembly and the component shown by the sub-code
  1. Component shown by the sub-code
01-D8
*2, *3
A component shown by the sub-code is (was) disconnected from the system after the engine starts.
01-D9
*1, *3
The device that had functioned before the engine stopped is (was) disconnected from the system while the ignition switch is (was) on (IG or ACC).
01-DA
*3
  1. No response is identified when changing mode.
  2. Sound and images do not change by pressing a switch.
01-DB
*1, *3
A dual alarm is detected.
01-DE
*3, *4
A slave device has been disconnected after the engine starts.

HINT:
  1. *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.
  2. *2: If the power connector is disconnected after the engine starts, this code is stored after 180 seconds.
  3. *3: If it is reported that the device does not exist during verification, check the power source circuit and AVC-LAN circuit for the device.
  4. *4: This code may be stored if the engine is started and then started again.

NOTICE:
  1. Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
  2. The navigation receiver assembly is the master unit.
  3. Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read DESCRIPTION before performing the following procedures.


1. CHECK "NAVIGATION RECEIVER ASSEMBLY COMMUNICATION ERROR" IN FLOW CHART
Refer to the "Navigation Receiver Assembly Communication Error" (Click here).

NEXT

END


← 01-D5 Absence of Registration Unit (+ 5 more codes) (May 2007 – Jul 2008)01-D6 No Master (+ 01-D7) (May 2007 – Jul 2008) →