2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

58-43 SPD Signal Error

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
58-43
A difference between the GPS speed and SPD pulse is detected.
  1. Speed signal circuit
  2. Navigation receiver assembly
80-43
A difference between the GPS speed and SPD pulse is detected.

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

  1. E120089
    Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.



NG
Go to step 2
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

2. PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Refer to "Speed signal does not change in the navigation check mode" in the problem symptoms table (Click here).

NEXT

END


← 58-43 SPD Signal Error (+ 80-43) (May 2007 – Jul 2008)58-44 Player Error (+ 80-44) (May 2007 – Jul 2008) →