2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

AVC-LAN Circuit

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

Each audio system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network.
If a short to +B or short to ground occurs in the AVC-LAN, the audio system will not function normally because communication is not possible.

INSPECTION PROCEDURE


1. INSPECT RADIO RECEIVER

  1. E200688E20
    Disconnect the radio receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E24-9 (TXM+) - E24-10 (TXM-)
    Always
    60 to 80 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver)



NG
REPLACE RADIO RECEIVER (Click here)
OK


2. CHECK HARNESS AND CONNECTOR

HINT:
For details of the connectors, refer to Terminals of ECU (Click here).

  1. Referring to the following AVC-LAN wiring diagram, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.

    2. Check for an open or short in all AVC-LAN circuits.

      OK:
      There is no open or short circuit.

      E162966E13



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MALFUNCTIONING PARTS
  1. Disconnect the slave unit and check if the master unit returns to normal operation.

    HINT:
    If disconnecting the slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the slave unit.

    OK:
    Master unit returns to normal operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE MALFUNCTIONING PARTS


← Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU (from Jul 2010)Microphone Circuit between Microphone and Radio Receiver (from Jul 2010) →