2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Reverse Signal Circuit

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch assembly to use for adjusting the vehicle position on the navigation display.

WIRING DIAGRAM

E176572E30

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
  1. Disconnect the E4 navigation receiver assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E4-5 (REV) - Body ground
    Ignition switch ON
    Shift lever in R
    11 to 14 V
    E4-5 (REV) - Body ground
    Ignition switch ON
    Shift lever in any position except R
    Below 1 V



NG
Go to step 2
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)
  1. Disconnect the E4 navigation receiver assembly connector and B5 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-5 (REV) - B5-1 (RL)
    Always
    Below 1 Ω
    E4-5 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - BATTERY)
  1. Disconnect the B5 park/neutral position switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    B5-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)


← AVC-LAN Circuit (from Jul 2010)Mute Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU (from Jul 2010) →