HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the following procedure to troubleshoot the air conditioning system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK |
| NEXT |
|
 |
|
|
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
| 4.CHECK CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning.
- Result:
Result
|
Proceed to
|
CAN DTC is not output
|
A
|
CAN DTC is output
|
B (Click here)
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Check for DTCs.
Write down the DTCs.
Clear the DTCs.
Check whether the DTCs recur.
Reproduce the problem symptoms in accordance with the DTCs that were written down, and check whether the DTCs recur.
- HINT:
- Refer to the DTC chart when any DTCs are output.
- Result:
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.REFER TO PROBLEM SYMPTOMS TABLE |
- Result:
Result
|
Proceed to
|
Fault not listed in problem symptoms table
|
A
|
Fault listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
DATA LIST / ACTIVE TEST (Click here)
Panel diagnosis (indicator check) (Click here)
Panel diagnosis (sensor check) (Click here)
Panel diagnosis (actuator check) (Click here)
Terminals of ECU (Click here)
| NEXT |
|
 |
|
|
| 8.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|