2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the following procedure to troubleshoot the air conditioning system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.
      NEXT

      4.CHECK CAN COMMUNICATION SYSTEM*
      1. Use the intelligent tester to check if the CAN communication system is functioning.

        Result:
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B
        (Click here)


      B.
      A

      5.CHECK FOR DTC
      1. Check for DTCs.

        1. Write down the DTCs.

      2. Clear the DTCs.

      3. Check whether the DTCs recur.

        1. Reproduce the problem symptoms in accordance with the DTCs that were written down, and check whether the DTCs recur.

          HINT:
          Refer to the DTC chart when any DTCs are output.

          Result:
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B


      B.
      A

      6.REFER TO PROBLEM SYMPTOMS TABLE

        Result:
        Result
        Proceed to
        Fault not listed in problem symptoms table
        A
        Fault listed in problem symptoms table
        B


      B.
      A

      7.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. DATA LIST / ACTIVE TEST (Click here)

      2. Panel diagnosis (indicator check) (Click here)

      3. Panel diagnosis (sensor check) (Click here)

      4. Panel diagnosis (actuator check) (Click here)

      5. Terminals of ECU (Click here)

      NEXT

      8.ADJUST, REPAIR OR REPLACE
        NEXT

        9.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2008 – Jun 2010)CUSTOMIZE PARAMETERS (from May 2007) →