2007-2013 Highlander Kluger · Service Manual SECURITIES

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from May 2007

DESCRIPTION

This circuit provides power to operate the transponder key ECU assembly.

WIRING DIAGRAM

B171367E02

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.


1. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY)

  1. B164266E14
    Disconnect the transponder key ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D37-1 (+B) - Body ground
    Always
    11 to 14 V
    D37-2 (IG) - Body ground
    Ignition switch OFF
    Below 1 V
    D37-2 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BODY GROUND)

  1. B164266E13
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-16 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY


← Door Courtesy Switch Circuit (from May 2007)Diagnosis Circuit (from May 2007) →