2007-2013 Highlander Kluger · Service Manual SECURITIES

Door Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from May 2007

DESCRIPTION

When an additional transponder key is registered, the transponder key ECU assembly detects the front door courtesy light switch open/closed condition, and enters the key registration mode.

WIRING DIAGRAM

B171320E04

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.


1. CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH CIRCUIT)

  1. B164266E12
    Disconnect the transponder key ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-7 (CTY) - Body ground
    Courtesy switch pushed
    (Door closed)
    10 kΩ or higher
    D37-7 (CTY) - Body ground
    Courtesy switch free
    (Door open)
    Below 1 Ω



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY

2. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

  1. B111600E08
    Remove the driver side front door courtesy light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Switch body
    Courtesy switch pushed
    (Door closed)
    10 kΩ or higher
    1 - Switch body
    Courtesy switch free
    (Door open)
    Below 1 Ω



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSPONDER KEY ECU - FRONT DOOR COURTESY LIGHT SWITCH)


← Security Indicator Light Circuit (from Jul 2010)ECU Power Source Circuit (from May 2007) →