B2797 Communication Malfunction No. 1
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC is output when an error occurs in communication between the transponder key amplifier and the transponder key ECU.- HINT:
- Some noise is found in the communication line.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2797 |
Keys are positioned too close to each other, or noise occurs in communication line |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU is replaced, register the key and ECU communication ID.
| 1. CHECK KEYS |
Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.

- Result:
Result
Proceed to
Key is not near other keys and key ring is not in contact with key grip.
A
Key is near other keys and/or key ring is in contact with key grip.
B
|
|
||||
| B | |
| 2. CHECK DTC OUTPUT |
Separate the keys from each other, or remove the key ring.
Delete the DTCs (Click here).
Insert a key into the ignition key cylinder and remove the key. Repeat for all the other keys of the vehicle.
- OK:
- B2797 output does not recur.
|
|
||||
| OK | ||
| ||
| 3. REPLACE TRANSPONDER KEY AMPLIFIER |
Replace the transponder key amplifier (Click here).
| NEXT | |
| 4. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Recheck for DTCs.
- OK:
- B2797 output does not recur.
|
|
||||
| OK | ||
| ||
