When the transponder key is registered, the transponder key ECU assembly outputs the key registration condition by lighting up, blinking or turning off the security indicator light.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT)
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Perform the Active Test according to the display on the tester.
Immobiliser:
Tester Display
Test Part
Control Range
Diagnostic Note
Security Indic
Security indicator light
ON/OFF
-
OK:
The security indicator light turns on and off according to the tester operation.