2007-2013 Highlander Kluger · Service Manual SECURITIES

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from May 2007


CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester on.

  4. Read the DTCs by following the directions on the tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester on.

  4. Erase the DTCs by following the directions on the tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

← DIAGNOSIS SYSTEM (from May 2007)DATA LIST / ACTIVE TEST (from May 2007) →