2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY

  1. E151014
    Disengage the 3 claws and remove the No. 3 air duct sub-assembly as shown in the illustration.


2. REMOVE QUICK HEATER ASSEMBLY (w/ PTC Heater)

  1. E151016
    Remove the 3 screws.

  1. Remove the quick heater assembly as shown in the illustration.


3. REMOVE BLOWER ASSEMBLY

  1. E151015
    Disconnect the connector.

  1. Remove the 2 screws.

  1. Disengage the 2 claws and remove the blower assembly.


4. REMOVE FRONT AIR OUTLET CONTROL SERVO MOTOR SUB-ASSEMBLY

  1. E151058E01
    Disconnect the 2 connectors.

  1. Remove the 3 screws and the front air outlet control servo motor sub-assembly.


5. REMOVE FRONT AIR MIX CONTROL SERVO MOTOR SUB-ASSEMBLY

  1. E151017
    Disconnect the connector.

  1. Remove the 2 screws and front air mix control servo motor sub-assembly.


6. REMOVE HEATER CLAMP

  1. E151019
    Remove the screw and the clamp.

  1. Disengage the 3 claws and remove the heater clamp.


7. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

  1. E151020
    Remove the heater radiator unit sub-assembly as shown in the illustration.

    NOTICE:
    Prepare a drain pan or cloth in case the cooling water leaks.


8. REMOVE ASPIRATOR (for Manual Air Conditioning System)

  1. E151022
    Disengage the 2 claws and remove the aspirator.


9. REMOVE ASPIRATOR (for Automatic Air Conditioning System)

  1. E151023
    Disengage the clamp.

  1. Disengage the 2 claws and remove the aspirator.


10. REMOVE COOLER EXPANSION VALVE

  1. E151024
    Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.


11. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

  1. E151025
    Disconnect the connector.

  1. Remove the 6 screws.

  1. Disengage the 5 claws and remove the plate cover.

  1. E151026
    Disengage the clamp and remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor.

  1. E151027
    Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.


12. REMOVE NO. 1 COOLER THERMISTOR

  1. E151028
    Remove the No. 1 cooler thermistor.

← REMOVAL (from Jul 2010)REASSEMBLY (from May 2007) →