B2271 Ignition Hold Monitor Malfunction
Diagnostic trouble codes · Vehicles built May 2007 – Jun 2010
Versions by build date: May 2007 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC is output if a problem such as an open in the AM2 fuse, an open or short in the wire harness between the fuse and main body ECU, a short in the IG output circuit inside the main body ECU, a short between the main body ECU and relay, and a short in the relay is detected.- HINT:
- If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2271 |
Hold circuit, IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU is open or shorted |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
- HINT:
- After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).
Check for DTCs again.
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY) |
Disconnect the D6 and D7 ECU connectors.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D7-6 (AM1) - Body ground
Always
11 to 14 V
D6-1 (AM2) - Body ground
Always
11 to 14 V
|
|
||||
| OK | ||
| ||
