2007-2013 Highlander Kluger · Service Manual ENGINE

B2271 Ignition Hold Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output if a problem such as an open in the AM2 fuse, an open or short in the wire harness between the fuse and main body ECU, a short in the IG output circuit inside the main body ECU, a short between the main body ECU and relay, and a short in the relay is detected.

HINT:
If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2271
Hold circuit, IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU is open or shorted
  1. AM2 fuse
  2. Main body ECU (Instrument panel junction block)
  3. Wire harness or connector

WIRING DIAGRAM

B165251E04

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

    HINT:
    After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
Go to step 2
OK

USE SYMPTOM METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY)

  1. B175597E03
    Disconnect the D6 and D7 ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D7-6 (AM1) - Body ground
    Always
    11 to 14 V
    D6-1 (AM2) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR FUSE
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← B2271 Ignition Hold Monitor Malfunction (May 2007 – Jun 2010)B2272 Ignition 1 Monitor Malfunction (May 2007 – Jul 2008) →