2007-2013 Highlander Kluger · Service Manual DRIVE LINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT SPIDER BEARING

  1. C166052
    Check the spider bearing axial play by turning the flange while holding the shaft tightly.

    HINT:
    If necessary, replace the propeller with center bearing shaft assembly.


INSPECT INTERMEDIATE SHAFT

  1. C166053
    Using a dial indicator, inspect the runout of the intermediate shaft.

    Maximum runout:
    0.4 mm (0.016 in.)

    HINT:
    If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.

  1. C166054
    Using a dial indicator, inspect the runout of the front side of the intermediate shaft flange.

    Maximum runout:
    0.1 mm (0.004 in.)

    HINT:
    If the intermediate shaft flange runout exceeds the maximum, replace the propeller with center bearing shaft assembly.

  1. C166055
    Using a dial indicator, inspect the runout of the rear side of the intermediate shaft flange in the horizontal direction.

    Maximum runout:
    0.1 mm (0.004 in.)

    HINT:
    If the intermediate shaft flange runout exceeds the maximum, replace the propeller with center bearing shaft assembly.

  1. C166056
    Using a dial indicator, inspect the runout of the rear side of the intermediate shaft flange in the vertical direction.

    Maximum runout:
    0.1 mm (0.004 in.)

    HINT:
    If the intermediate shaft flange runout exceeds the maximum, replace the propeller with center bearing shaft assembly.


INSPECT PROPELLER SHAFT ASSEMBLY

  1. C166057
    Using a dial indicator, inspect the runout of the propeller shaft.

    Maximum runout:
    0.4 mm (0.016 in.)

    HINT:
    If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.


INSPECT NO. 2 CENTER SUPPORT BEARING ASSEMBLY

  1. C166058
    Turn the bearing by hand while applying force in the rotation direction. Check that the bearing turns smoothly.

  1. Check that the seals are not cracked or damaged.

    HINT:
    If the bearing is damaged, worn, or does not turn freely, replace it.


INSPECT NO. 1 CENTER SUPPORT BEARING ASSEMBLY
  1. Inspect the No. 1 center support bearing assembly by following the same procedures as the No. 2 center support bearing assembly.


INSPECT REAR PROPELLER SHAFT

  1. C167205
    Using a dial indicator, inspect the runout of the rear propeller shaft.

    Maximum runout:
    0.4 mm (0.016 in.)

    HINT:
    If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.

← DISASSEMBLY (from May 2007)REASSEMBLY (from May 2007) →