The main body ECU (instrument panel junction block) detects the condition of the back door opener switch.
The main body ECU (instrument panel junction block) receives signals from the back door opener switch and activates the back door lock motor according to the signals.
The main body ECU (instrument panel junction block) detects the condition of the back door courtesy switch.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. SYSTEM CHECK
Check if the vehicle is equipped with a back door closer system.
Result:
Result
Proceed to
w/ Back Door Closer System
A
w/o Back Door Closer System
B
A
GO TO BACK DOOR CLOSER SYSTEM (Back Door cannot be Opened) (Click here)
B
2. READ VALUE USING INTELLIGENT TESTER (BACK DOOR OPENER SWITCH)
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select Back Door Open Handle in the Data List and read the tester display.
Main Body (Main Body ECU):
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Back Door Open Handle
Back door opener switch/ON or OFF
ON: Back door opener switch is pushed OFF: Back door opener switch is not pushed
-
OK:
On the tester screen, the item changes between ON and OFF according to the chart above.